Care And Maintenance; Filter Replacement - AO Smith AO-WH-PREV El Manual Del Propietario

CARE AND MAINTENANCE

INSTALLATION GUIDE
AO-WH-PREV
Replacement filter AO-WH-PREV-R2
Rated service flow 6.0 gpm
Water supply: community / private well
Water pressure 25-100 PSI
Water temperature 40-100º F
TROUBLESHOOTING
Water leaks at fittings:
Slowly tighten until leak stops.
Water leaks at connections:
Push pipe in as far as it will go. If leaking
continues, shut off water and remove
water line by pushing in on connector
collar while pulling the pipe away. Inspect
pipe. If pipe is cracked or scratched, cut
off the end as straight as possible and
reinsert new pipe end into fitting.
CLEANING:
The exterior of your filtration system
can be cleaned with warm, soapy water.
Rinse well with fresh, clean water. Never
use chemical cleaning products on the
system's exterior surface as they may
damage the housing.
TIPS
Before changing filter, turn off water supply.
Place a bucket under filtration system to catch
the small amount of water that will run out after
housing removal. If non-A. O. Smith brand filter is
used, installer must ensure the replacement filter
is appropriate.

FILTER REPLACEMENT

We recommend changing the
AO-WH-PREV-R2 filter every six (6) months.
It should be replaced earlier if there is a
significant drop in water pressure.
1. Turn off the water using the wrench
supplied. Turn valve on filter head to
the "OFF" or "BYPASS" position. (See
Wrench/Handle Operation below).
2. Unscrew housing and remove old filter.
Wash housing thoroughly with mild
soap and water and rinse thoroughly.
3. Insert new filter and re-install housing.
Ensure filter is seated and centered in
housing before tightening onto head.
4. Hand-tighten housing on filter head
until snug. If necessary, use filter wrench
to fully tighten the housing and ensure
a good seal. DO NOT OVER-TIGHTEN.
5. Turn on water by turning valve on filter
head to the "FILTER" position. If leaks
appear, tighten housing as needed.
6. Flush system for five (5) minutes.
Wrench/Handle Operation
Align blue wrench handle
with black filter handle.
Alinee el mango de la llave azule
con el mango negro del filtro.
NEED HELP? GIVE US A CALL 877.333.7108
Secure connection with
hand and turn handle.
Fije la conexión con la mano
y gire el mango.
5