Operating Instructions - Audiovox VME 9122 TS Manual De Instrucciones

OPERATING INSTRUCTIONS

Power On / Off
Press the /SRC button (6) on the unit (or the / POWER button (4) on the remote control) to turn the unit on. The
buttons on the front of the unit light up and the current mode status appears in the TFT(7). You can also turn on the unit
by pressing the OPEN button (1) and opening the TFT screen.
Press and hold the button to power off the unit.The monitor is drawn back into the main compartment.
Audible Beep Confirmation
An audible beep tone confirms each function selection. The Beep tone can be disabled through the Setup menu.
Volume Adjustment
To increase or decrease the volume level, turn the rotary encoder (5) on the front panel or press the VOL+/ VOL but-
tons (15, 16) on the remote control. When the volume level reaches "0" or "40", a beep sounds, indicating that the
adjustment limit has been reached. The volume ranges from "0" to "40". The TFT screen displays the volume level for
3 seconds.
Programmable Turn-On Volume
This feature allows the user to select a turn-on volume setting regardless of the volume setting prior to turning the unit
off. To program a specific turn-on volume level, turn the AUDIO control (2) to adjust the volume to the desired turn-on
volume. Push and hold the AUDIO button while the yellow speaker icon and level indication is displayed on the screen.
The unit will beep two times to confirm your turn-on volume setting.
Mute
Press the MUTE button on the front panel (8) or remote control (3) to mute the volume from the unit. Press the MUTE
button again to restore the volume. "MUTE" is displayed on the TFT. Adjusting the volume or using any of the audio
setup features cancels the mute function.
Line Mute
If the "MUTE" wire is connected, audio output mutes when a telephone call is received by the car phone.
69