Checking The Workpiece During A Running Program; Moving The Service Position; Moving To The Change Position For The Blank Holder - IDC Mikro Modo De Empleo

To continue the program:
▷ With the door closed, briefly press operation
button [A].
The program is continued at the position where
it was stopped. Operation button [A] lights up.
On completion of the program, the machine
returns to the starting position. Operation button
[A] goes out.
6.5 Checking the workpiece during a
running program
▷ Push and hold operation button [A] for at least
three seconds.
The program is interrupted. The spindle returns
to the rear, the current tool is placed down and
the workpiece is turned around. While travel-
ling, operation button [A] is lit; after reaching
the position, it flashes.
▷ Visually check the workpiece.
▷ Briefly push operation button [A].
The tool is picked up again. The spindle travels
to the position, where the program was inter-
rupted. While travelling, operation button [A] is
lit; after reaching the position, it flashes.
▷ Briefly push operation button [A].
The program is continued. Operation button [A]
lights up.
6.6

Moving the service position

The service position can be moved to from the
starting position or from an interrupted program.
▷ Briefly press service button [B].
The current tool is placed down and the spindle
returns to the service position. The spindle is
released; the motor is blocked. While travelling,
operation button [A] is lit; after reaching the
position, it flashes.
A P P L I C A T I O N A N D O P E R A T I O N
To exit the service position:
▷ Briefly press operation button [A].
The tool is picked up again. The spindle travels
back to the starting position or to the position,
where the program was interrupted. While trav-
elling, operation button [A] is lit; after reaching
the position, it flashes.
6.7 Moving to the change position for
the blank holder
The change position for the blank holder can only
be moved to from the starting position.
▷ Push and hold operation button [A] for at least
three seconds.
The current tool is placed down. The blank
holder is turned in such a manner that the fas-
tening screw becomes accessible. While travel-
ling, operation button [A] is lit; after reaching
the position, it flashes.
To exit the change position for the blank holder:
▷ Briefly press operation button [A].
The machine moves to the starting position.
E N
35