Walk Test; Troubleshooting - koban KDP5 Manual De Instrucciones

KDP5
Highbay presence detector
Walk test (Lux setting is invalid)
The purpose of conducting the walk test is to check and adjust the detection
coverage.
Test procedure
• Tester must be within the detection coverage.
• Switch power on.
• The detector takes approx. 30sec to warm up with load and LED keeps on,
then turn off after warming up time.
• Walk from outside across or toward to the detection coverage until LED
and load turn on for 2sec (See FIG.21).
• Adjusting Meter knob for desired detection range.
Trouble shooting
Problem Possible cause
Lighting 1. Wired incorrectly.
device does 2. Malfunctioned load.
not turn on
Lighting 1. Detector is nuisance
device does triggered.
not turn off 2. Wired incorrectly.
Instructions manual |
FIG.21
34
Suggested solution
1. Connect the load referring
to the wiring diagrams (See
FIG.5 - FIG.8 ).
2. Replace the disabled load
with a new one.
1. Connect the load referring
to the wiring diagrams (See
FIG.5 - FIG.8 ).
2. Make sure load and wires
are connected correctly.
www.grupotemper.com