Walk Test - koban KDP6 Manual Del Usuario

1S.
1S.
www.grupotemper.com

Walk test

The purpose of the walk test is to
select a proper installation place
and gain the desired detection
coverage. Turn METER knob to
W
"+", TIME knob to "Test",
then conducting a walk test
referring to step 4.1 (See FIG 18).
W
NOTE
It takees approx. 60 sec to warm
up after power is supplied, then
W
enters into normal operation
mode.
Test procedure
•
•
W
•
Wall presence detector
Switch power on
User must be within the
detection coverage.
After the warming up period,
walk from outside across to
the detection pattern until
LED turns on for approx. 2
sec.
Instructions manual |
KDP6
37