After Use & Storage - Romus RLS160 Instrucciones De Uso

1. Pull out and turn the Cord Hook to release the Power Cord. Unwrap the Power Cord and plug it
into a properly grounded outlet
2. Pull up on the Handle Release Compression Lever (6). Move the Operator Handle (8) downward
until your arms are almost straight. Release the Handle Release Compression Lever (6) to lock the
Operator Handle (8) in place
3. Lift up on the Operator Handle (8) until the brush (or pad) is flat against the floor.
WARNING! Be prepared to control the machine as soon as the motor starts. Just a slight up or
down movement of the Handle will make the machine move from side to side. Raise the Handle to
go right. Lower the Handle to go left.
CAUTION! Immediately start moving the machine back and forth. Keep the machine moving while
the motor is running to avoid damage to the floor.
4. Hold the Operator Hand Grips (2) firmly, push the Safety Lock Button (1) and then compress the
Switch Levers (7) to start the motor.
NOTE: The Safety Lock Button (1) will not depress unless the Operator Handle (8) has been released
and tilted back into the operating position. When the dual controlled Switch Levers (7) are
released, the machine shuts off immediately.
NOTE: When spray buffing, check the pad every 15 minutes for dirt and wax build-up. If the pad is
dirty, turn it over to expose the clean side or install a clean pad.
1. Place the Operator Handle (8) in the upright position and unplug the Power Cord .Wrap the
Power Cord around the Operator Handle Grips (2) and the Cord Hook.
2. Remove the pad holder or brush from the machine. Clean the pad or brush and hang it up to dry.
Allow buffing pads to dry completely before using again.
Store brushes and pad holders separate off the machine. Never store the machine with the pad
holder or brush loading on the machine.
3. Wipe the entire machine with a clean, damp cloth. Wipe the underside of the brush housing after
wet use.
4. Inspect the entire machine and all accessories for damage. Perform any required maintenance or
repairs before storage.
5. Store the machine in a clean, dry place with the Operator Handle (8) locked in the upright
position.
OPERATION
AFTER USE & STORAGE
MONOBROSSE « RLS160 »| Réf. 194460
GB
8