Clearing A Jam - ACCO Brands Pinnacle 27 Manual Del Usuario

d. Ensure top and bottom film edges are
aligned.
Step 7: Replace the feed table and close the Heat
Shield. Turn the top roll of film an extra ¼ turn to
create slack in the film off the top roll. (Fig 16a)
Step 8: Using the film threading card included with
the film, push the film into the NIP of the Heat Rollers.
Continue to push the threading card while the
Forward button is hit in step 9. (Fig 16b)
Step 9:
Using the RUN button, push until rollers start moving
while watching the film thread through the Heat &
Pull rollers and observe the film exiting the back of
the laminator.
OPERATION
1. Move the Main Power switch to the 'ON' ( )
position (figure 1).
2. Ensure the proper film is selected.
3. When the laminator reaches operating
temperature, the green ready indicator on the
control panel will illuminate.
4. Position the item(s) to be laminated on the feed
table.
5. Press the RUN button.
6. Slide the item(s) to be laminated into the Heat
Rollers.
7. When the laminated item(s) exit the rear of the
laminator, hit the Stop Button.
8. Use the Rear Slitter located at the back of the
laminator to separate the laminated item(s) from
the film web.
9. During use watch the film exit to ensure film is
not drawn back into exit to prevent film wraps.
Note: Continuously feeding similar size media in the
same location will create a wear spot. Mixing up the
feeding location will give heat rollers longer life.

CLEARING A JAM

Film jams may occur if the laminator is not
positioned to allow exiting film to drop freely to the
floor. Accumulation of laminate as it exits the
laminator may cause film to wrap around the roller,
causing a jammed condition.
To clear a jam it is necessary to rotate the rollers in a
reverse direction.
1. Immediately stop the laminator by hitting the
Stop Button
2. Open the Heat Shield and remove the Feed
Table
3. Cut the top and bottom film webs by the Idler
bars
4. Grasp the loose ends of the film web and pull
straight out while pushing
Reverse Button.
5. When the film has cleared the Heat Rollers
stop the laminator by letting go of
Button
6. Re-thread the film following the FILM
LOADING instructions earlier
Lamination Speed Guide
Media Type
Thin (News Print)
Medium (Copy Paper)
Thick (Card Stock)
Heavy Stock (Poster Board)
Lamination Tips

Do not attempt to laminate abrasive or
metal items such as staples or paper clips as
they will damage the heat rollers.

Do not force items into the nip area of the
rollers. An item that is not easily drawn into
the laminator is probably too thick to
laminate.

Wrinkles may result if an attempt is made to
reposition an item once the rollers have
grasped it.

Do not stop the laminator before an item
has completely exited the rear of the
laminator. Even a momentary stop will
cause a mark (heat line) to appear on the
laminated item.

Adhesive will be deposited on the Heat
Rollers if:
- Only one roll of film is used. The top
and bottom rolls must be used for
problem free lamination.
- One or both rolls of film are allowed to
run completely off the core.
- Top and bottom roll film edges are not
evenly aligned
and holding the
the Reverse
Speed
Nap I Nap II
4 – 5 4 – 5
3 – 5 3 – 5
2 – 3 2 – 3
1 - 2 1 - 2