Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Assembling Remaining Bagger
Components
With the mounting brackets assembled
and in place on the tractor, follow these
steps to assemble the remaining bagger
components.
1.
Tilt the front of the upper chute
support (631-05491B) slightly
forward. Slide the clip behind the
tab, then snap the front latch to the
rail, as shown in (1) of Figure 4-6.
2.
Snap the upper chute support
in place by first clipping the side
portion onto the bagger support rail.
See (2) in Figure 4-6.
Figure 4-6
3.
Slide the left side grass catcher
cover (731-12350B) over the upper
chute support and the bag support
assembly. Carefully latch the two
tabs in place into the front of the
upper chute support, see 1 in Figure
4-7. Fit the snaps onto the left side
bagger rail support. See 2 in Figure
4-7.
1
2
Figure 4-7
8
S
4 — A
ection
SSembly
4.
From the front of the assembly,
line up the tabs on the upper grass
catcher cover with the tabs at the
front of the upper chute support
(931-05474B). Slide the hinge pin
through the slots beginning at the
right side upper chute support of the
mounting tabs, as in Figure 4-8. Push
the pin (711-06701) all the way in
until it reaches the end-stop.
NOTE: The pin clips into place and is
secured by a tab on each side of the
bagger cover.
5.
Swing the upper grass catcher cover
down to close the attachment. Push
in on the rear right-side and rear
left-side tabs and lock them into
place under the notches on each
side. Ensure a secure, snug fit. See
Figure 4-9.
& i
nStAllAtion
Figure 4-8
Figure 4-9
6.
Open the bagger cover by pushing
in on the tabs and lifting the upper
grass catcher cover. See Figure 4-10.
Figure 4-10
7.
Install both grass bag assemblies
(964-05104) onto the bag support
brackets by inserting the front edge
in first, as shown in Figure 4-11, and
setting the back edge down until it
fits into the assembly.
1
Figure 4-11
Publicidad
Tabla de contenido
