Setting Up Your Network Usb Hub; Important - Belkin F5L009ea Manual Del Usario

Setting Up your Network USB Hub

The Hub works with Windows
1
(32-bit). In order to use the Hub, you must have a networking
router connecting your network.
2
1. Preparing for Setup
NOTE: If you are connected to a network router that uses
3
Dynamic Host Configuration Protocol (DHCP), which most
networks do, you do not need to set up your Hub.
4
1.1 Plug the AC adapter into the Hub.
5
1.2 Check the Power LED (green). It should be illuminated.
1.3 Plug the Ethernet cable into the Hub.
1.4 Plug the other end of the Ethernet cable into your
network router.
2. Installing the Software
IMPORTANT: If you do not install the software on your PC,
the Hub will not work.
2.1 Insert the setup CD into
your CD-ROM drive.
You will see the Hub
Setup CD screen. Click
"Install Control Center".
XP and Windows Vista
®
uk-2 uk-2
™