Setup; Charging Battery; Fuel Cell Preparation - Campbell Hausfeld MF349099 Instrucciones De Operación, Instalación Y Mantenimiento

Operating Instructions and Parts Manual

Setup

Read all instructions for tool setup BEFORE putting the tool into use.

CHARGING BATTERY

Before using the tool, make sure battery is fully charged.
You must charge the battery before using the tool. Only use the
battery meant for this tool. Do not use or attempt to use other
battery types with this tool.
Setup the charger and charge the battery fully before first use of the tool.
Before plugging the charger into the outlet receptacle:
◆
Make sure the voltage on the charger base and adaptor is compatible with the
outlet receptacle
◆
Make sure the power cord of the charger system is not damaged
Do not charge the battery at a voltage higher than indicated on the
charger. This may cause damage to the battery or the charger.
To charge the battery, do the following:
1. Place the battery into the charger (see Figure 1). Make sure the battery is securely in
the charger.
2. Plug the adaptor into the outlet receptacle.
3. Insert the power cord of the adaptor into the charger base (see Figure 2).
4. Charging will begin as soon as the charger and adaptor are connected (see
Figure 3). The green LED light on the charger will turn on continuous to indicate
charging has begun. If the LED light does not turn on, remove battery and reinsert
battery back into charger base. The battery is fully charged when the green LED on
the charger base is flashing. Once the battery is fully charged, remove the battery
from charger. DO NOT leave it on continuous charge to avoid possible damage to
the battery.
5. The red LED light will turn on if a problem exists.
NOTE: The battery charging time can be affected by the temperature of the area where
the charger is being used.
6. Once charged, unplug the battery charger adaptor from the outlet receptacle.
Do not pull the adaptor out of the outlet receptacle
by pulling on the adaptor cord. This could cause the
cord to break and may cause electrical shock or property damage. If the
cord is yanked and damaged, DO NOT use for charging. Exposed wires can
cause an electrical shock.
7. Remove the battery from the battery charger.
Hints to extend battery life:
◆
Recharge the battery before it is completely exhausted.
◆
Avoid recharging the battery at high temperatures.
◆
After charging, wait for the battery to cool to room temperature before use.
Do not immerse battery or charger in water for any
reason. Serious shock and damage to unit may occur.

FUEL CELL PREPARATION

See fuel cell manufacturer instructions for instructions, warnings,
and disposal information.
The fuel cell is fl ammable. Keep away from
open fl ame or any source which may ignite the
fuel cell.
If the gas of the fuel cell leaks from the
metering valve or the fuel cell itself after
attaching the metering valve, replace with a new metering valve.
Do not attempt to reuse the metering valve.
To attach the metering valve to a fuel cell, do the following:
1. Remove shipping cap / metering valve from the fuel cell, if
applicable. See Figure 4.
2. Remove the metering valve from the protective cap, if
applicable. See Figure 5.
Figure 1
Figure 2
Red
LED
Green LED
Figure 3
Figure 4
NF349099
Figure 5
www.chpower.com 7