Important Parts; Disposable Nebulizer; Reusable Nebulizer; How To Operate Your Compressor - DeVilbiss Healthcare Pulmo-Aide 3655D Guía De Instrucciones

ImPORTANT PARTS

DeVilbiss 3655 Compressor (Figures A & b)
1. Power switch
2. Filter (non-washable)
3. Air-outlet connector
4. Carrying handle
5. Power cord storage recess

Disposable Nebulizer

1. Mouthpiece
2. T-piece
3. Corrugated Tubing
4. Cap
5. Baffle
6. Medication Cup
7. Nebulizer Air-Inlet Connector
8. Tubing
Nebulizer parts are not sold separately. Additional nebulizers
(part #3655D-621) are available through your DeVilbiss provider.
Reusable Nebulizer (Optional)
1. Mouthpiece
2. T-piece
3. Corrugated Tubing
4. Cap
5. Baffle
6. Medication Cup
7. Nebulizer Air-Inlet Connector
Nebulizer parts are not sold separately. Additional nebulizers (part #900D-610) are available through your DeVilbiss
provider.

HOw TO OPERATE yOUR COmPRESSOR

NOTE– Before initial operation, your nebulizer should be cleaned following cleaning
instructions, or as recommended by your physician or DeVilbiss provider.
1. Place compressor on a level, sturdy surface so that the controls can be easily
reached when seated. Never block the air openings of the product or place it on a
soft surface, such as a patient's lap or a bed or couch where the air openings may be
blocked.
2. Make sure the power switch is in the "Off" position (Fig. 1). Unwrap power cord and
plug power cord into an appropriate wall outlet (refer to Specifications). Plug model
3655 into a grounded wall outlet.
DANGER
DeVilbiss compressor/nebulizer must be operated on the specified power source to
avoid risk of electric shock and damage to the compressor.
3. Wash hands.
4. Connect one end of the nebulizer tubing to the compressor air-outlet connector
(Fig. 2).
NOTE–During high-humidity weather conditions, condensation (water build up) can occur in
the nebulizer tubing.
5. Assemble clean nebulizer and add prescribed medication (Fig. 3).
6. Assemble mouthpiece, t-piece, and corrugated tubing (if applicable) and insert into
the top of the nebulizer cap. If using an aerosol mask, insert the bottom part of the
mask directly into the top of the nebulizer cap.
7. Attach tubing to nebulizer air-inlet connector (Fig. 4).
8. Press the power switch "On" (Fig. 1) to start the compressor.
EN - 4
2
3
1
5
4
Figure A
1 3
2
4
5
6
7
Disposable Nebulizer
Figure B
1
2
4
5
6
8
7

Reusable Nebulizer

Figure 1
Figure 2
5
3
A-655