Somnetics Transcend AUTO Guía Rápida página 7

ASSEMBLING YOUR TRANSCEND AUTO
To completely assemble the Transcend Auto:
1. Attach the Universal Hose Adaptor to the 6-foot air supply tube then connect the universal hose
adaptor to the Transcend Auto making sure it is fully seated into the APAP.
2. Connect the interface (mask) to the patient (open) end of the 6-foot hose.
3. Plug the power supply barrel connector into the APAP with the cord pointed up.
4. Connect the power supply to a power source.
2
4
1
Note: Your Transcend AUTO can also be powered by the optional
Transcend Mobile Power Adaptor or Transcend Battery.
Note: When power is supplied to the APAP, the yellow light will flash
once followed by three quick flashes of the green LED light. This
sequence indicated power is being supplied to the device and that it
has successfully entered Standby mode.
Note: Do not use a power converter with your Transcend as it may
damage the device. Transcend automatically converts voltage.
TRANSCEND AUTO QUICK GUIDE
3
• ENGLISH • PAGE 7