Step 1 - Where Will You Install; Step 2 - Check Your Connector Type - Ebode LughtSpeaker Guia Del Usuario

Instruction Manual
Step 1: Decide which light will be replaced with
®
LightSpeaker
Your ebode electronics LightSpeakers
specifically designed to cover large areas, however if the
location of your fixtures allow you to do so, you should think
about how you use your room and where you are likely to
spend most of your time. Then choose the fixtures that
are most evenly spaced to your preferred listening position.
WARNING!
Turn off circuit breakers to all
lighting fixtures you are working on!
A) Turn off the circuit breaker and light switch, to the
bulb you intend to replace with a LightSpeaker
B) Remove the existing light bulb.
Step 2: Check your connector type. Your ebode
electronics LightSpeaker
E27 socket. It will not fit any other type connector.
STOP!
Check your connector!
.
® is designed to fit into a standard
® have been
® .
9