Setting Up The Flat-Panel Monitor; Power Management System - Dell PowerEdge 17FP Guia Del Usuario

F i g u r e 1 - 3 . B a c k V i e w

Setting Up the Flat-Panel Monitor

Follow the steps below to set up the flat-panel monitor.
• If the monitor has not yet been operated, ensure the flat-panel monitor has been connected to an AC
power source. See the Rack Installation Guide.
• Pull the flat-panel monitor tray out until it locks. Grasp the monitor by its handle and rotate it to
approximately a 90 degree angle.
• Press the power button to turn on the monitor. See Figure 1-4 and Table 1-5.
• To adjust the monitor height, grasp the monitor at both sides and use equal pressure on both sides to
move it up and down.

Power Management System

This flat-panel monitor complies with the VESA DPMS (version 11) power management standard. The
VESA DPMS proposal provides four phases of power saving modes by detecting horizontal or vertical
sync signal. See Table 1-3 for information about power consumption for each different power
management mode.
The LED indicator color will be half-bright when the monitor is in power saving mode.
1-9
Us er 's Guide