7
Hook the Base bracket to the Joint
fitting and secure it temporarily
Hook the Base bracket on the protrusion (A)
of the Joint fitting, and secure it temporarily
using the four supplied M5 screws (B).
● Pull out the cables as shown.
● Be sure to secure screws (B) tightly after making
the adjustment discussed in "Adjusting the
Projection Angle " (page 11).
8
Connect cables
1 Connect cables to the projector.
2 Affix the supplied Canon logo seal as
shown.
After completion of installation, adjust
the projection angle (page 11).
For WUX10 MarkII/SX7 MarkII/SX60/X700,
affix an additional seal at the back.
B
A
B