Installation Instructions; Important Safety Information - Garmin Panoptix PS22 Instrucciones De Instalación

PORTABLE ICE FISHING KIT

Installation Instructions

Important Safety Information

See the Important Safety and Product Information guide in the
chartplotter or fishfinder product box for product warnings and
other important information.
To obtain the best performance, you must install the Garmin
device according to these instructions.
Read all installation instructions before proceeding with the
installation. If you experience difficulty during the installation, go
to support.garmin.com for more information.
Battery Information
Battery Warnings
The Garmin device uses a user-replaceable, sealed, lead-acid
battery. If these guidelines are not followed, the battery may
experience a shortened life span or may present a risk of
damage to the device, fire, chemical burn, electrolyte leak,
and/or bodily injury.
• Do not place the battery near objects that may cause sparks,
flames, or heat.
• Do not incinerate the battery.
• Do not use a sharp object to remove the battery.
• Do not disassemble, puncture, or damage the battery.
• Do not swallow, touch, or inhale the contents of an open
battery. Avoid contact with internal acid. Contact with internal
acid may cause irritation or severe burns. Irritation may occur
to the eyes, respiratory system, and skin. Flush with water at
once if contact is made with acid.
• Do not submerge the battery and avoid contact with water.
• Do not short the battery terminals.
• Do not drop or throw the battery.
• Keep the battery away from children.
• Only replace the battery with the correct replacement battery.
Using another battery presents a risk of fire or explosion of
the device or charger.
• Only charge the battery with the included charger.
• Do not charge the battery in an unventilated area.
• Store in a cool, dry, and well-ventilated area.
• Do not charge the battery in a gas-tight container.
• Do not leave the device exposed to a heat source or in a
high-temperature location, such as in the sun in an
unattended vehicle. To prevent damage, remove the device
from the vehicle or store it out of direct sunlight.
• Do not use organic solvents or other cleaners other than
recommended chemical cleaners on the battery.
• Contact your local waste disposal department to dispose of
the battery in accordance with applicable local laws and
regulations.
• When storing the battery for an extended time, store within
the following temperature range: from 5° F to 104°F (from
-15° C to 40° C).
• Do not operate the battery outside of the following
temperature range: from 5° F to 122° F (from -15° C to 50°
C).
Battery Tips
• The length of time a fully charged battery will last before fully
discharging varies based on many factors, such as device
2
WARNING
WARNING
backlight brightness, the temperature, and the age of the
battery.
• You can lower the backlight brightness level to help extend
the battery life.
• The life expectancy of a sealed, lead-acid battery can be
extended by frequently recharging and not completely
discharging the battery.
• Sealed, lead-acid batteries slowly lose their charge while in
storage. For best results, charge the battery prior to use.
• When used in cold temperatures, sealed, lead-acid batteries
®
do not hold the charge as long as in warmer temperatures.
• Sealed, lead-acid batteries are completely recyclable.
Portable Ice Fishing Kit Specifications
Battery Temperature
discharge
At -20°C (-4°F)
At 0°C (32°F)
At 20°C (68°)
Battery type Sealed, lead acid, 12 Ah
Battery life Up to 11 hr.
NOTE: The actual battery life of a fully charged
battery can vary based on the device used, backlight
brightness, temperature the battery is operated and
stored in, age of the battery, and depth of the water.
Battery shelf life 1 mo.: 92%
after charging
3 mo.: 90%
6 mo.: 80%
Battery operating From 5° to 122°F (from -15° to 50°C)
temperature
range
Battery charging From 5° to 104°F (from -15° to 40°C)
temperature
range
Battery storage From 5° to 104°F (from -15° to 40°C)
temperature
range
Physical size, 12.25 in. × 14.45 in. × 10 in. (311 mm × 367 mm ×
assembled kit 254 mm)
with device (L ×
W × H)
Weight, 15 lb. (6.65 kg)
unassembled kit
with device
GT10HW Ice Traditional: 130 to 300 kHz (High Frequency, Narrow
fishing Beam, CHIRP)
transducer
frequencies
GT10HW Ice 500 W
fishing
transducer
transmit power
(RMS)
GT10HW Ice User adjustable, from 8 to 16°
fishing
transducer beam
width
Panoptix ™ PS22 Specifications
Dimensions (W x H x L)
Transducer weight
Total weight (transducer, mount,
and cable)
Max. continuous power usage
Screen Time
brightness
100% 7.4 hr.
50% 9.75 hr.
100% 9.83 hr.
50% 10.2 hr.
100% 10.3 hr.
50% 11.1 hr.
32 x 118 x 96 mm (1.3 x 4.6 x
3.8 in.)
380 g (0.84 lb.)
840 g (1.85 lb.)
8 W
Installation Instructions