Binks 83C-210-CE Manual Del Usuario página 6

Condition
Air escaping from port on
Regulator cap
Pressure creepage registered on
gauge
Air leakage from Safety Valve
below maximum working pressure
Fluid or air leak at Lid Gasket
Note: Occasionally check gauge (Ref. No. 9). The needle should return to zero with no pressure on
the gauge.
ACCESSORIES
PT-78-K10 & PT-78-K60 Liner.
A
p o l ye t h yl e n e
tank
reduce
clean up time.
The
made of tough,
d u r a b l e ,
l e a k p r o o f
p o l ye t h yl e n e
and can be re-
used. May be used with all
materials that are compatible with
polyethylene. (Available
packages of 10 and 60 only.)
© ITW Finishing Systems & Products 2009
8/13 ©2013 Binks
Ref. 10 HAR-511 REGULATOR ASSEMBLIES
Service Checks
Cause
Broken or damaged diaphragm
(ref No. 34)
Dirty or worn valve seat in
regulator
The Valve seat is dirty or
damaged, or the valve stem assy
is seized
Defective Lid Gasket (ref. No. 2)
Thumb Screws not sufficiently
tight
PT-413 Air Regulator Kit.
Used to convert single regulated
tanks (fluid
m oulded regulation (fluid and air). Used
with portable air compressors or
liner to with air lines when no other
tank means (air
regulators)
liner is
regulation is available.
in
Page 6
Page 6
Ref. Part No. Description
No.
28 KK-4977 Repair Kit
+ 29 ——– "O" Ring
+ 30 ——– Spring
+ 31 ——– "O" Ring
+ 32 ——– Valve
+ 33 ——– "O" Ring
+ 34 ——– Diaphragm Assembly
Replace diaphragm
Clean or replace valve seat
Replace Safety Valve. Do not
attempt to repair.
Replace gasket
Tighten Screws
Ball Valves.
only), to dual To add a Ball valve to the Air
Inlet, remove Nipple (ref. No. 29).
Replace with Ball Valve VA-5432-
K (NPS) or VA-5427-K (BSP).
transformers or
of air pressure VA-540 Fluid outlet shut-off
valve. To install, remove the
adapter (Ref. No. 16), replace
with Ball valve VA-5429-K (BSP)
or VA-5424-K (NPS) (taper thread
to regulator).
Using these valves will simplify
attachment of air and fluid hoses.
Individual
Parts Req.
1
1
1
1
1
1
1
Correction