Kenmore 116.39050 Manual De Uso Y Cuidado página 23

HOSES
Always follow all safety precautions when
performing maintenance to the vacuum
cleaner_
WARN6NG
Electrical Shock Or Personal injury
Hazard
Disconnect electrical supply before
performing maintenance to the
vacuum cleaner. Failure to do so
could result in electrical shock or
personal injury from the vacuum
cleaner suddenly starting.
If the vacuum cleaner does not seem to
have adequate suction, first check if the dust
cup is full or if a filter is clogged. See DUST
CUP CLEANING section,
If the dust cup and filter areas are free of
clogs, check the extension hose.
TO REMOVE CLOG FROM
HOSE
1. Rotate the extension hose release lever
counter-clockwise to release extension
hose
Extension _I
Wand
Holder
Extension Hose
Release
2. Remove the lower end of the extension
hose from the wand holder by grasping the
hose collar, twisting, and pulling straight up.
3. Plug in the vacuum cleaner and turn it on.,
4. Stretch the extension hose to maximum
length and then allow the hose to return to
its natural length.,
Hose Storage
Position
Hose
_:_ _.
5. Re-insert the hose into the original
storage position from which it was removed.
Press firmly to assure connection,
6. Rotate hose release lever clockwise to
the locked position.
If the dust cup, filter area and the hose
areas are free of clogs, disconnect the
nozzle hose from the wand holder and
check the nozzle for clogging
d WARNING
Personal Injury' Hazard
DO NOT place hands or feet under-
neath the vacuum cleaner at any
time.
Clean the agitator according to the
instructions in the AGITATOR CLEANING
section.
Return the vacuum cleaner to the upright
position before plugging into an electrical
outlet,,
23