Clog Removal - Kenmore 116.39050 Manual De Uso Y Cuidado

MOTOR PROTECTION
SYSTEM
Thermal Protector- Suction Motor
This vacuum cleaner has a thermal
protector which automatically trips to
protect the vacuum cleaner suction motor
Ifa clog prevents the normal flow of air to
the motor, the thermal protector turns the
motor off automatically This allows the
motor to cool in order to prevent possible
damage to the vacuum cleaner
Thermal Protector - Agitator Motors
This vacuum cleaner has thermal
protectors which automatically trip to
protect the agitator motorsThe thermal
protectors turn the motors off
automatically, This allows the motors to
cool in order to prevent possible damage
to the vacuum cleaner_
CAUTION
Always return the vaccum cleaner to
the upright position before using the
hose and attachments. Failure to do
so may result in overheating of the
agitator motors and can cause the
thermal protectors to trip.
To reset thermal protectors: Turn the
vacuum cleaner off and unplug the power
cord from the outlet to allow the vacuum
cleaner to cool and the thermal protectors
to reset
Check for and remove clogs, and
empty dust cup if necessary. See
CLOG REMOVAL section. Also check
and replace any clogged filters. Wait
approximately 40-50 minutes before
restarting vacuum cleaner.
Motor Protector
This vacuum cleaner has a motor protector
by-pass valve which prevents motor
overheating and damage The valve opens
to provide cooling air when a clog prevents
normal air flow to the vacuum cleaner
suction motor You will notice a change of
sound as air rushes through the valve
opening.
Motor
Protectol
To correct problem empty the dust cup
and clean the primary filter. If using
attachments, adjust to allow for greater
air flow.
NOTE: The motor protector may open
when using attachments or when cleaning
new carpet due to reduced airflow caused
by the attachments themselves or by new
carpet lint filling the dust cup quickly_
Note: Do not block motor protector.
14