GRE L4PL Manual De Instrucciones página 3

Note: The two holders need to be snapped into the groove in the same direction.
3. Install four treads to the holder, see the picture as below. Fix the top tread to the holder by #10x1-1/4 screws.
4. Fix the left and right fi xing strips with bolt & gasket( M6), and nut M6*85!, do not over tighten (the accessories are
in screw kit 5862050002 )
Left fi xing strip
5. Use # 10x1-1 / 4 screws to fi x other three treads. Then put aside for further processes.
Tighten with two screws for both sides
Holder
Need to be fi xed by screw
Tighten with screws for both right and lift
sides
Gasket
Nut
Fix the treads to the left and right fi xing
strips with screws
Bolt
Right fi xing strip