GRE L4PL Manual De Instrucciones página 5

11. Fix the remaining two treads with 10x1-1/4 screws to the holder in the groove positions
12. This ladder is designed to fi t multiple pool heights. This ladder is designed to fi t multiple pool heights.
If you pool height is 52 .Locate the fi rst line on the handrail of the ladder. Using a hacksaw cut the handrail evenly through
both sides.
If the pool height is 48 " locate the second line on the handrail, and using a hacksaw cut the handrail evenly through both
sides# Locate the line on the holder and cut the redundancies evenly through both sides.
No cut needed, if your pool height is 54
13. Using a funnel fi ll both holders with sand. Use approximately 20 Lbs. of sand in each holder. The barrier in step 11
have the front and back barrier!
Install the treads with screws
Cut line
Cut line
Fill holder with sand using a funnel
cut line for holder