GRE L4PL Manual De Instrucciones página 6

14. Assemble handrails to the platform, center cover cap opening on side of handrail where platform was just attached.
Using a rubber mallet/hammer, tap on cap until the cap is fl ush with handrail.
15. Attach handrails by pushing them down over the holders.
16. Secure all handrails to the legs with #10 1-1/4# screws$
Pushing them down
over the holders
17. Place assembled ladder inside the pool where you would like to enter and exit. The entrapment barrier should be
inside of the pool. Once the ladder is placed in the pool, tip the ladder forwards and backwards and side to side to
release any air that may be trapped inside.
When a Ladder is installed it is recommended that a Step Mat should be installed underneath. THIS ITEM IS SOLD SEPA-
RATELY
The swing up outer tread
is at the outside of pool
18. A-Frame ladder must be fi xed on the edge of the pool. First, align the two holes on the surface of the deck platform
with the edge of the pool, mark the hole positions at the edge of the pool with a fi ne marker pen, then drill through
the edge of the swimming pool with a 5 / 16 "drill bit, and fi nally use bolts, nuts and washers to fi x the ladder on the
edge of the swimming pool.
Cover Cap
Use 5862050000 screw kit 2.5 bolt if your pool height is 48
Use 5862050001 screw kit 5 bolt if your pool height is 52
Use 5862050001 screw kit 5 bolt if your pool height is 54
Handrail
Deck Plate form
Screw