Bell SRT Serie Manual Del Propietário página 9

2. With the chin strap snug under your chin, grab the helmet in the rear at the base and try to pull
the helmet forward on your head. Do the same test except grab the helmet in the front and try to roll
the helmet rearward. If the helmet comes off your head, the helmet does not fit right and you should
not wear it. This is also important. Check to make sure the chin strap is tight periodically while you
ride. If the chin strap has become lose, immediately stop and re-tighten the chin strap. If you have any
questions about fit, see your dealer, or contact Bell's Consumer Services group at 1-800-456-BELL.
mWARNING!
Do not wear a motorcycle helmet which does not fit right. Failure to follow this instruction could
lead to serious personal injury or death. If you have purchased one of our full-face models, check the
position of your eyes in relation to the eye opening of the helmet. Check to make sure that the helmet
is positioned on your head so that you have adequate downward and upward vision to properly
operate your vehicle. Adjust the position of the helmet on your head to achieve this relationship.
Protect Your Eyes
Your new SRT Series helmet is equipped with a face shield that must be used at all times in
order to adequately protect your face and eyes. Tinted face shields, goggles, or other forms of
tinted eye protection should not be used at night or under other conditions of poor visibility.
Lenses damaged by scratches will reduce visibility, especially at night, and should be replaced.
Petroleum products and other solvents may impair the optical properties and reduce the
mechanical strength of shields and should not be used. Replacement shields can be obtained
from your dealer or by calling 1-800-456-BELL.
10