General Safety Regulations - Zhermack SAB 1000 Manual De Uso Y Mantenimiento

AUTHORIZED PERSONNEL
2.3
The operator-user must only use the equipment when it is fully assembled and the
safety devices are working properly as described in this manual.
Before using this equipment or carrying out any work on it, the operator must read
the entire contents of this manual. This manual has been drawn up to
provide the user with essential information on rational, safe utilisation of the
equipment. The user must comply with the information given at all times. Furthermore,
the user must use the work sheets enclosed with this manual so as to keep a record of
maintenance/component replacement work as well as make notes on any equipment
malfunctions.

GENERAL SAFETY REGULATIONS

2.4
The operator must read the advice and warnings given below and comply with such regulations at all
times: doing so will ensure safe, long-lasting equipment performance:
• Do not allow untrained personnel to use this equipment.
• Ensure that the work area is properly prepared: it must be free from obstacles, clean and properly
illuminated.
• Take measures to ensure that you are not distracted when using the equipment.
• In the event of a malfunction follow the advice given in this manual: if you have any doubts shut
down the equipment and contact your Authorised Service Centre immediately.
• Never use a malfunctioning equipment and always inform the Maintenance Manager of any faults.
• Do not open compartments containing electrical parts.
• Do not replace the power lead or tamper with the supplied plug.
• It is forbidden to use the equipment on items other than those for which it has been specifically
designed.
• Before doing any cleaning, routine and/or unscheduled maintenance work make sure that the
equipment has been unplugged from the mains socket.
• Make sure that there are no foreign objects inside the work area as these could damage the
equipment and/or injure personnel.
• Do not use petrol or flammable solvents as detergents; use only non-flammable, non-corrosive, and
non-toxic substances (see paragraph 8.1);
• Do not used compressed air to clean small pieces; if you do so you should protect your eyes with
goggles that provide lateral protection and limit air pressure to a maximum of 2 bar.
88 of 136
MAINTENANCE AND USE MANUAL
EN
SAB 1000