LUTEC 12513LE-SL Instrucciones De Armado Y Uso página 4

area with a minimum of 8 hours of direct sun exposure.
Note: Charging conditions differ by time zone locations and affects total hours of light discharge.
PREPARATION
Before beginning to assemble or install lighting fixture, make sure all parts are present. Compare
parts with package contents list and hardware contents list. If any part is missing or damaged, do
not attempt to assemble, install or operate the product.
Estimated Assembly Time: 30-60 minutes.
Tools Required for Assembly: Flathead Screwdriver, Phillips Screwdriver, Pliers, 1/2'' Wrench,
ladder and hammer.
DETERMINE DESIRED INSTALLATION-PERMANENT CONCRETE PAD OR GROUND STAKE
INSTALLATION: PERMANENT CONCRETE PAD
Thread three J Anchor Bolts into the I Excavate a hole in the ground that measures
Concrete Mounting Bracket allowing for 2" (5cm) at minimum 10" (26cm) in diameter and has a
minimum depth of 5" (12cm).
above the Mounting Bracket.
Fill hole with concrete and insert I and J before
the concrete dries.
Note: The concrete and the concrete mounting bracket I should be at GROUND LEVEL, with
the anchor bolts J 2'' (5cm) above the ground.
4