Bissell PowerGlide Pet Bagged 3863 Serie Manual Del Usuario página 5

A
ssembly
The only tool you'll need to assemble your
vacuum cleaner is a Phillips-head screwdriver.
attach handle to vacuum
1. Locate the vacuum handle and remove
the screw packet taped to the base of
the handle.
2. Stand the vacuum upright and slide the
base of the handle firmly into the grooves
at the top of the vacuum body.
3. Check to be sure the handle is fitted to
the vacuum body. If there is a gap in
front, continue to push firmly until the
handle is flush.
4. Insert the screw provided from the screw
packet into the existing hole. Tighten
securely with a screwdriver.
attach vacuum hose and tools
1. Line up tabs on the base of the Twist 'n
Snap hose with the corresponding notches
on the hose collar. Turn the hose to the
right to lock into place.
2. Grasp the Quick Reach Handle and
slide the end of the hose into the hose
wand base. Snap the hose into the
upper hose clip on handle.
3. Slide the extension wand and crevice
tool together into storage clip.
4. Snap the combination tool into the
storage clip.
5. Attach the Pet TurboEraser Tool by lining
up with base of holder in handle and
push back to snap into place.
w w w . b i s s e l l . c o m
2.
4.
1.
4.
5.
8 0 0 . 2 3 7 . 7 6 9 1
3.
2.
5