Kohler Sterling 660B Serie Guía De Instalación Y Cuidado página 9

3.
Drill and Mark the Wall Jamb
3/16" Diameter Holes
Orifices de Ø 3/16"
Orificios de 3/16" de diámetro
3" (7.6 cm)
3"
Pencil
(7.6 cm)
Crayon à papier
Lápiz
Wall Jamb
Montant du mur
Jamba mural
Press and hold legs together.
Presser et maintenir les pieds ensemble.
Sostenga juntas las patas.
Level
Niveau bulle
Nivel
Bottom Track
Inside of Bath/Shower
Rail inférieur
Intérieur de baignoire/douche
Carril inferior
Interior de la bañera/ducha
Place one wall jamb on a flat surface. Position the wall jamb with the grooved side
faced up.
Along the center groove drill a 3/16" hole 3" (7.6 cm) from each end of the wall
jamb.
Drill the third hole 3" (7.6 cm) from the center point of the wall jamb.
Position a wall jamb against the wall directly over the bottom track. The wall jamb
should sit flat against the wall.
Slide the wall jamb down over the bottom track until the wall jamb and bottom
track are fully engaged.
IMPORTANT! The wall jamb must sit flat on the bottom ledge. If your ledge has a
curve in the corners at the side wall, it may be necessary to shape the bottom end of
the wall jamb with a file.
Use a level to plumb the wall jamb vertically.
Using the pre-drilled screw holes as a guide, mark the hole locations on the wall.
Repeat the procedures with the second wall jamb.
Remove the bottom track and wall jambs.
NOTE: When installing on ceramic tile, use a center punch to nick the surface of the
glaze. Tap the center punch lightly with a hammer to avoid cracking the tile.
Lightly center punch the hole locations.
Drill a 5/16" hole at each mark. Use a tile or masonry bit for ceramic tile.
Sterling
Wall Jamb
3" (7.6 cm)
Montant du mur
Jamba mural
Bottom Track
Rail inférieur
Carril inferior
Wall Anchor
Ancrage mural
Anclaje mural
Anchor/Ancrage/Anclaje
9
Straight Wall Jamb
Montants du mur droits
Jamba mural recta
Bottom Track
Rail inférieur
Carril inferior
1063215-2-D