Bosch PLH181 Instrucciones De Funcionamiento Y Seguridad página 14

2610052973.qxp_PLH181 12/23/19 3:00 PM Page 14
any rabbeting depth from 0 to 5/16
inch. For best results, it is important
that the blade be properly aligned (See
"blade ALIGNMENT"). The width of the
rabbet is controlled by the width fence.
The maximum cutting width is 3-1/4"
(82mm), and the final depth is achieved
by repetitive cutting until the rabbeting
depth guide contacts the workpiece.
The maximum rabbeting depth is 5/16"
(8mm) (Fig. 11).
Setting the rabbet depth: Loosen wing
knob and using the depth scale on the
rabbeting depth stop, set the desired
rabbet depth. Securely tighten wing
knob.
Unclogging the shavings
exhaust system
becomes necessary
shavings. The blades are hidden from
view and you may be cut if blade is
contacted.
To minimize the possibility of clogging,
make sure:
1. The depth of cut is reasonable for the
material.
2. The feed rate is reasonable for the
material. (See "Depth Of Cut And
Feed Rate")
3. Unplug the planer and carefully insert
a screwdriver or similar object into
the exhaust port to break up the clog.
Operating Instructions
Disconnect battery
pack from tool if it
to remove
-14-
Fig. 11