INFOSEC UPS SYSTEM E2 LCD 600 Guía De Usuario página 10

E 2 L C D - 6 0 0 / 8 0 0
Problem
Nothing displays on the
front LCD panel but the
mains is normal.
Alarm continuously
sounds when the
mains is normal.
When power fails, back-
up time is shorten.
The mains is normal but
the UPS is in battery
mode.
E 2 L C D - 1 0 0 0 / 1 5 0 0 / 2 0 0 0
Problem
No words display on the
front panel even though
the mains is normal.
Battery backup time is
shorter than nominal
value.
Warning or fault icon is
shown and alarm is
continuously sounding. The UPS is overload.
Low battery icon is
shown on the LCD
screen.
INFOSEC UPS SYSTEM - 4, rue de la Rigotière - 44700 Orvault - FRANCE - www.infosec-ups.com
10
Hot Line – Tel + 33 (0)2 40 76 15 82 - Fax + 33 (0)2 40 94 29 51 - hotline@infosec.fr – 01 10 AA 59 205 09
Possible Cause
Low battery.
The UPS is not turned on. Press the power switch again to turn
The UPS is overload.
The UPS is overload.
Battery voltage is too low. Charge the UPS at least 4 hours.
Battery defect. It might be
due to high temperature
operation environment, or
improper operation to batt.
Power cord is loose.
Possible Cause
AC input is not connected
well.
AC input is connected to
the UPS output.
Batteries are not fully
charged.
Batteries defect.
Fan is locked or not
working.
Low battery icon is shown
on the LCD screen.
Solutions
Charge the UPS at least 4 hours.
on the UPS.
Remove some loads first. Before
reconnecting equipment, please
verify that the load matches the UPS
capability specified in the specs.
Remove some critical load.
Replace the battery with the same
type of battery.
Reconnect the power cord properly.
Solutions
Check if the input power cord is
firmly connected to the mains.
Plug AC input power cord to AC
input correctly.
Charge the batteries at least 6 hours
and then check the capacity again.
If the problem still persists, please
consult your dealer.
Contact your dealer to replace the
batteries.
Check fans and notify your dealer.
Remove some loads first. Before
reconnecting devices, please verify
the total loads match the UPS
capability specified in the spec.
Charge the UPS at least 6 hours.