Optimus M130 Instrucciones De Seguridad página 29

M130
8x8 Audio Matrix
9. Talk button and record button.
Press this button to give a emergency warning with max priority.
The corresponding zone LED will display "P".
When not broadcasting a message for any area, press this button for more than three seconds
to record an alarm message. In the LED display will show "RECORD" indicating that it's in
recording process. When you finish record your message, press the ESC button to exit.
10. Button to select or cancel all areas.
Press this button to select all areas and press it again to cancel. To give an emergency
warning click a zone of 1~8, or pressing "ALL" and then press "TALK" to transmit the message
to the desired zones.
11. Labels with the name of each output zone.
Show the names of each zone.
12. Volume control for background music.
Volume control of background music for each zone.
13. LED display of background music channel for each zone.
The LED display shows in each zone, the current channel which is playing music. You can
change it pressing the selection button of the background music or the remote control M134P /
M134T.
14. Buttons to select the input channels for background music in each zone.
Select the auxiliary audio input 1~8 for zones 1~8.
15. Presence Led for M134P and M134T.
The Led shows whether the presence is on or off. The remote control panel can only be used
when the LED is lit.
16. Button to enable the controller M134P and M134T.
It's used for enable or disable the remote wall controller M134P or M134T connected to each
output zone.
If the button is on, select the background music and adjust the output volume using the
controllers M134P and M134T.
If the button is off, the controller is not available. In this case, the volume of the starting zone
returns to its original state and can only be set by the matrix controller M130.
17. Volume control for the monitor speaker.
Adjust the volume for the monitor speaker.
M130 Version 1.0 Page 6 of 23