Denon DHT-T110 Manual Del Usuario página 13

The Controls on Top of DHT-T110
1
1) power on/standby
2) Television Input Listen to sound from the television; auto-selects the active signal.
Should multiple inputs have signal present, priority is given to optical-digital, coaxial-digital,
and 1/8" (3.5 mm) analog stereo mini plug, in that order.
3) Bluetooth® Input Listen to wireless audio streamed from your Bluetooth enabled mobile device.
(see "Using Bluetooth®" on page 15).
4) remote Learning Press to engage Learning Mode. (see "Use Any Remote to Control your DHT-T110" on page 16).
5) Listening Mode Toggles through the three Listening modes (see "Listening Modes" on page 14).
6) Mute sound Mutes the audio; press again to unmute. (Pressing either Volume key also unmutes).
7) Volume down Press-and-hold to continuously decrease the volume.
8) Volume up Press-and-hold to continuously increase the volume.
About DHT-T110's Automatic Power Modes
DHT-T110 will automatically "wake-up" whenever any of its wired inputs receives an audio signal. Simply turning on your
television will also turn on DHT-T110. (For Bluetooth playback you will need to turn on DHT-T110 manually using the remote
control or top panel. controls). Because of DHT-T110's power saving design, the system takes five to seven seconds to turn
on from standby. Pressing either the front-panel Television Input or Bluetooth keys will also power up the DHT-T110. Press the
Power key again to return DHT-T110 to its low-power "standby" mode. DHT-T110 will automatically return to standby after five
minutes of not receiving any audio, for example, after you turn off your television set.
If you wish to change this auto-on behavior you may switch between the standard automatic wake-up/standby mode,
and a manual power on/standby mode. To change from one to the other, press-and-hold the front panel Power key for
three seconds. The power key LED will flash bright for three seconds, then illuminate steadily for three seconds, and then go
completely dark, indicating you have changed to manual power mode. Each time you repeat the Power-key press-and-hold it
will change to the other mode. In manual power mode DHT-T110 is switched to on or standby with a momentary press of the
Power key.
DHT-T110E3_140805.indd 13
2 3 4 5 6 7 8
13
2014/08/05 10:41:27