Mounting The Camera - Swann PRO Serie Manual De Instrucciones

Mounting the Camera

The camera mounts onto a flat surface using screws. The surface must have sufficient
strength to hold the camera. Materials such as hardwood, brick or masonry are good
options, and we've included all the gear you'll need to mount it there (except the tools -
sorry, you'll still need your own drill). You can mount the camera onto a metal surface, but
you'll need to supply your own mounting hardware.
To mount the camera:
• Using the small hex key (supplied), undo the three small locking bolts on the sides of
the PRO-CAM dome.
• Remove the top parts of the dome, consisting of the camera itself and the dome cover.
• Attach the base plate of the dome to the ceiling or wall in the position you'd like using
the supplied screws. If mounting to brickwork, concrete or other masonry surface, use
the included wall plugs.
• Aim the camera in the direction you'd like. It can help to move a monitor or television
out to the camera's location to ensure you get it aimed and positioned properly.
• Once the camera is aimed, re-attach the dome cover.
Tips: Positioning your Cables
• When running your cable, try to avoid bending it at sharp angles.
• Don't put your cable near live electrical wiring. AC electricity generates radio "noise"
which can interfere with the signal from your camera.
Tips: Weather Resistance
• The PRO-CAM is built to be weather resistant. It'll stand up to getting wet occasionally,
but it's not intended to be underwater all the time. When mounting the camera, ensure
that it's not in a location where water is likely to pool or build up over time.
• Long term exposure to direct sunlight will adversely affect the camera. Over time, the
infrared and ultraviolet radiation will eventually begin to degrade the integrity of the
plastic and rubber components of the dome (particularly the seals, cable, protectors
and so on). Basically, put it in the shade!
• The dome itself is weather resistant, but the cables (most importantly the plugs) are
not. Ensure that all wiring and the connectors are suitably insulated and protected
from moisture and sunlight.
Tips: Night Vision
• Don't place the camera so that there are any objects near the lens. Even transparent
or seemingly inconsequential objects (such as glass or spider's webs) will reflect
infrared light, and effectively blind the camera at night.
3