Environmental Protection - Crown CT13576 Manual Original

Switching the power tool on / off
[CT13576]
Switching on:
Set on / off switch 4 into the "ON" position�
Switching off:
Set on / off switch 4 into the "OFF" position�
[CT13577]
Switching on:
Press the back part of on / off switch 4 and while
holding it in this position, move on / off switch 4 for-
ward� Press the front part of on / off switch 4 to fix it in
pressed position�
Switching off:
Push the back part of on / off switch 4�
Recommendations on the power tool op-
eration
Before starting operation switch on your
tool for testing, if the grinding attach-
ments are well fixed and to make sure,
that there is no radial grinding attachment
run - out. If the radial run - out is detected, switch your
power tool off and replace the faulty attachment.
• Switch your power tool on, wait for the spindle to
reach maximum speed and only then start getting the
grinding surface close to the blank treated�
• Best grinding results are achieved, when the power
tool is moved smoothly, while being slightly pressed on�
• Avoid applying excessive pressure on your power
tool, as it will not produce better results, but will over-
load the motor and lead to a quicker grinding attach-
ment wear-out�
• Never use the grinding attachments, which are worn
out in a non - uniform way�
• Grinding attachment defects (deviation in cylindrical
form, non - uniform wear - out, etc�) may be corrected
with honing stick� Caution: never attempt to correct
radial grinding attachment run-out with honing stick.
The manufacturer reserves the possibility to introduce changes.
Power tool maintenance / preventive
measures
Before carrying out any works on the power tool it
must be disconnected from the mains.
Cleaning of the power tool
An indispensable condition for a safe long-term exploi-
tation of the power tool is to keep it clean� During the
long treatment of metal, current - conducting dust can
be accumulated inside the power tool. Regularly flush
the power tool with compressed air thought the ventila-
tion slots 3�
After-sales service and application service
Our after-sales service responds to your questions
concerning maintenance and repair of your product as
well as spare parts� Information about service centers,
parts diagrams and information about spare parts can
also be found under: www.crown-tools.com�
Transportation of the power tools
• Categorically not to drop any mechanical impact on
the packaging during transport�
• When unloading / loading is not allowed to use any
kind of technology that works on the principle of clamp-
ing packaging�

Environmental protection

Recycle raw materials instead of dispos-
ing as waste.
Power tool, accessories and packaging should
be sorted for environment - friendly recycling�
The plastic components are labelled for categorized
recycling�
These instructions are printed on recycled paper man-
ufactured without chlorine�
English
18