koban KDP7 Serie Manual De Instrucciones página 23

Problem Possible cause
Lights do not 1. TIME setting is too
turn off
long, detector is
continuously triggered.
2. Sensor is nuisance
triggering.
3. Incorrect location of
detector.
4. Wiring is connected
incorrectly.
Lights go on 1. With the incorrect
and off quickly
location, the detector is
nuisance triggered by
heat from the lamps.
2. There are white or
highly reflective objects
within the detection
coverage.
Note
Keep the lens area clean and free of obstructions. Do not attempt to open or
repair the unit. There are dangerous high voltages inside.
www.grupotemper.com
Motion detector light control
Suggested solution
1. Setting TIME to "-",check if the
detector is nuisance.
2. Keep away from detection zone to
avoid activating detector while doing
the test.
3. Make sure unit is not aimed at object
that would cause the temperature
changing such as air conditioners or
heating vents.
4. Make sure load and wires are
connected correctly.
1. Select another location.
2. Check if there is any white or
reflective surface in the protection
pattern. Then adjust sensor and lights
in different directions.
Instructions manual |
KDP7
23