Troubleshooting - koban KDP7 Serie Manual De Instrucciones

KDP7
Motion detector light control
Note
The following conditions may cause lower sensitivity:
• In very foggy nights, the sensitivity may be less due to moisture collecting
on the lens.
• In very hot days, the sensitivity may be less since high ambient temperature
is close to body temperature making the unit to be less sensitive.
• In very cold days when heavy clothing is dressed, especially the facial area
is covered, very little heat will be emitted from the body causing the unit to
be less sensitive.
• Cleaning - Wipe with damp cloth only. Soap or polish may damage the
sensor lens.

Troubleshooting

Problem Possible cause
Lights do not 1. LUX knob set
turn on
incorrectly.
2. Time to power
resupply is less than
5sec.
3. Power does not switch
on, malfunctioned bulb,
or incorrect wiring.
4. Incorrect direction of
detector head.
Instructions manual | 22
Suggested solution
1. Adjust LUX knob to " ".
2. Shut power off for at least 5sec, then
turn it again.
3. Check if the power is supplied, or
replace the bulb with a new one, or
refer to wiring diagram to connect the
wiring.
4. Adjust the detector head to desired
direction.
www.grupotemper.com