5.
PARTS LIST
Water Heater
Water Heater with Mounting Feet
Warranty Registration Card
Instruction Manual Including Installation Templates
Tank
Insulation
Tank Casing
Blanking Plate
PCB
6.
INSTRUCTIONS FOR INSTALLATION
To the Fitter:
Installation and servicing of this appliance must only be carried out by competent persons registered with the Gas
Safe Register (GB) or the relevant national organisation, in accordance with the relevant regulatory and safety
WARNING
requirements.
Before installation, ensure the appliance has been supplied in good condition and if damaged do not install
and contact Webasto.
A competent person must install the appliance in accordance with the appliance installation instructions. This
appliance is for use with LPG (see appliance data plate). You must check that the product is suitable for the
intended application. In particular, the installer must check the compatibility of the data plate information with the
LPG supply requirements of the vehicle. Follow these installation instructions and ensure that all relevant personnel
read the points listed below. Also ensure that these operating instructions are passed on to the end user.
Please note: The appliance must be installed in accordance with any relevant regulations in the country where the
appliance is installed. For this appliance in Europe, the standard is BS EN 1949:2011 "Specification for The
Installation of LPG Systems for Habitation Purposes in Leisure Accommodation Vehicles and Accommodation In
Other Road Vehicles" applies.
Onboard Models
Fig.1 Components Drawing
5
Underfloor Models
1
1
1
1
1
1
Cold Inlet Seal
Drain Valve Lever
Box Lid
Cold Inlet 12mm
Hot Elbow 12mm
Overheat Stat
Pressure Relief
Control Thermistor
Burner Assembly
Flue Seal and Bush
Condensate Drain Ball
Solenoid Seal