LaserLiner RollPilot S12 Manual De Instrucciones página 7

To measure from wall to spot
5
1. Position the device with the rear of
the measuring wheel against the wall.
2. Move the measuring wheel straight
to the marked spot.
3. Read off the measured value and
add the radius of the wheel.
To measure from spot
6
to spot
1. Position the pointer (9) on the first
marked spot.
2. Move the measuring wheel straight
to the other marked spot.
3. Read off measured value.
Information on maintenance and care
Clean all components with a damp cloth and do not use cleaning agents, scouring agents and solvents.
Store the device in a clean and dry place.
Calibration
The meter needs to be calibrated and tested on a regular basis to ensure it produces accurate
measurement results. We recommend carrying out calibration once a year.
Technical data
Subject to technical alterations. 20W03
Precision
Measurement range
Measuring wheel radius
Measuring wheel circumference
Functions
Units
Operating conditions
Storage conditions
Dimensions (W x H x D)
Weight
EU directives and disposal
This device complies with all necessary standards for the free movement
of goods within the EU.
This product is an electric device and must be collected separately
for disposal according to the European Directive on waste electrical
and electronic equipment.
Further safety and supplementary notices at:
http://laserliner.com/info?an=AET
R +
± 0.1%
0 – 9,999.9 m
159 mm
1000 mm
Length measurement, Addition and subtraction of lengths
m
-20°C ... 80°C, max. humidity. 80% rH, no condensation,
max. working altitude 4000 m above sea level
-30°C ... 80°C, max. humidity 80% rH
318 x 1000 x 140 mm
1800 g (without accessories)
RollPilot S12
Measurement
Measurement
07
EN