Petporte Smart Fl Ap ® Quick Guide - Petsafe Microchip Petporte smart flap Guia Del Usuario

Petporte smart fl ap
Function
Normal Mode
Night Mode (Timer Mode)
Vet Mode
Program Entry
Extended Modes
Key Pad Lock
Erase Mode
Reset to Normal Mode
®
Quick Guide
Button Activation
This is the default mode on powering up
and requires no button activation.
Press the Red Button for
less than 2 seconds
Press the Red Button for
more than 2 seconds
Press and hold the Green Button for
more than 10 seconds
Press and hold both the Red and Green
Buttons for more than 2 seconds
Press and hold the Red Button for
more than 30 seconds
Press and hold both the Red and Green
Buttons for more than 30 seconds
Press and hold the Green Button for
more than 30 seconds
Mode Button Function
The red light will illuminate.
In Night Mode: During the hours of
darkness, the green light will illuminate.
The unit will not allow the cat to exit. At
dawn, the green light will extinguish and
the lock opens and the cat can go outside
again until dusk.
In Timer Mode: The unit will Lock and
Unlock at specifi c programmed times of day.
The red light will then fl ash and the unit
will not allow any cats to go out.
The green light will fl ash and you then
have 30 seconds in which to program
your cat by passing the animal under
the porch.
The unit will emit a long beep indicating
that the extended modes are now
available and the green light will be lit.
(See the Extended Modes - Quick Guide
on page 14)
The unit will emit a series of beeps
indicating the unit is now locked.
The unit will emit a series of short beeps
followed by a long beep. Both lights
should now be fl ashing.
Note: Once the unit's memory has been
erased, it will have to be re-programmed
before further use!
The unit will emit a series of short beeps
followed by a long beep. Both lights
should extinguish. Hold both buttons
down simultaneously for more than 30
seconds and UPON RELEASE the unit
emits a long beep.
13