Led Indicator - Quick Guide; Battery Backup Facility - Petsafe Microchip Petporte smart flap Guia Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 59
To set the LOCK time: This function needs to be carried out at the time of day when you wish the unit to CLOSE and remain LOCKED.
Enter the Extended Modes by pushing the Red and Green buttons simultaneously for more than 2 seconds, then press the red button
once (the unit will beep twice) then again (the unit will beep three times) then again (the unit will beep four times) then again (the unit
will beep fi ve times) then once again (the unit will beep six times) then once again and the unit will beep 7 times and you have arrived
at Timer Mode. To enter Timer Mode, press both Red and Green buttons simultaneously, the green light will stay illuminated and the
red light will fl ash.
Pressing and releasing the Red button quickly will set the LOCK time. On releasing the Red Button the Petporte smart fl ap® will return
to its normal mode of operation.
You must now activate Night Mode so that the unit recognizes the UNLOCK and LOCK times that you have programmed. To
activate Night Mode, press the Red button for less than 2 seconds.
Note:
1. The Timer Mode will only function when the unit is powered through the external power supply included with this unit. The Timer
Mode is not available when the unit enters battery backup mode.
2. In the event of a power cut, you will need to reset the unlock and lock times.
3. The Timer Mode supersedes the light level detector. The unit will no longer read the ambient light levels to decide if the unit should
be locked or unlocked.

LED Indicator - Quick Guide

Explanation of LED Indicators:
Flash
Off
Off (Day) / On (Night)
Off
Flash
On

Battery Backup Facility

Your Petporte smart fl ap
®
has the facility to fi t a backup battery, ensuring your cat can still have access to your house in the event of a
power cut on the low voltage power supply.
To install batteries, remove the small cover plate with a screw driver and attach a 9-volt PP3 battery to the connecting snaps. Push
battery into the battery compartment and snap the small cover plate back in place.
Please note that the following functions are currently unavailable with your Petporte smart fl ap
1. Wall Mounting - Currently the Petporte smart fl ap
2. Night Mode - Currently Night Mode is unavailable when the unit enters battery backup mode.
18
Flash
Off
On
Flash
Off
Flash
®
Battery Backup Facility is unable to function on a wall fi tted unit.
Function
Power on but nothing programmed
Normal Operating Mode
Night Mode (Timer Mode)
Vet Mode
Open Mode
Battery Level Low
®
, when the unit is being operated by battery alone:

Publicidad

Tabla de contenido
loading

Tabla de contenido