Connecting Cable Tv - Insignia NS-42PDP Guia Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Connecting cable TV

Your TV has a 75 ohm jack for connecting cable
TV.
Some cable TV providers scramble the signals
for "premium" (pay) channels. To view these
channels you need a converter/descrambler
box.
If you do not have a converter/descrambler box,
you can connect your cable TV directly to your
TV. If you have a converter/descrambler box,
you can connect your cable TV using an RF
switch (not supplied). For more information
about connecting a converter/descramble box,
contact your cable TV provider.
To connect cable TV without a
converter/descrambler box:
1 Connect one end of a 75 ohm cable to the
coaxial jack on the back of your TV.
2 Connect the other end of the cable to the
cable TV wall outlet.
To connect cable TV with a
converter/descrambler box:
Use the following illustration to connect a
converter/descrambler box. (The RF switch
and the signal splitter are not provided.)
Set the RF switch to the A position to watch
unscrambled channels using your TV remote
control. Set the RF switch to the B position to
watch scrambled channels using the
converter/descrambler controls.
RF switch
A
B
Out
Cable converter/descrambler box
10
Connecting a sound system
Warning
Note
Two-set signal
splitter
In
www.insignia-products.com
Insignia NS-42PDP 42" Plasma TV
Use the following illustration to connect an audio
processor or Hi-Fi system.
Make sure that you turn off and unplug your TV before
installing devices.
For home theater systems, use an S/PDIF cable to achieve full
sound capabilities.
S/PDIF cable
S/PDIF IN jack
Audio processor
Hi-Fi system

Publicidad

Tabla de contenido
loading

Tabla de contenido