Auto Address; Set Elec. Consumption - Panasonic CZ-RTC5 Instrucciones De Instalación

Setting

Auto address

3
Set.
(Select the Code no. [A1] and O/D unit no.)
▲ ▼ → ► →
(Repeat)
Code no.
Set the Auto address for each O/D unit no.
A1
Select the O/D unit no. (outdoor unit) for Auto address.
Note
 After RC. setting mode, Detailed settings or Auto address is complete, the unit
restarts.
Attention
 Set Auto address after all units are turned on and 1 minute and 30 seconds or
more have passed.
 Operate the units after Auto address is set and 1 minute and 30 seconds or more
have passed.

Set elec. consumption

3
Set.
(Select the power supply voltage of outdoor units.)
▲ ▼ →
Note
 Set the power supply voltage of outdoor units to calculate electric consumption of
the Power consumption monitor.
 If the setting differs from the power supply voltage of outdoor units, the electricity
display error may occur.
 Depending on the outdoor unit model, this cannot be set.
 When 3-phase model connections are used for outdoor units
Power supply voltage
380 V
400 V
415 V
 Auto address
Setting value
220 V
230 V
240 V
 Set elec. consumption
Code no.
O/D unit no.
• Outdoor unit number
O/D unit no.
13
(EN)