Connections - Johnson Controls Kantech INTEVO Compact LTE Guía De Instalación Rápida

Mechanical Loading - If you are mounting the equipment in the rack, it must be
l
such that an hazardous condition is not achieved due to uneven mechanical
loading.
Circuit Overloading - You must give consideration to the connection of the
l
equipment to the supply circuit and the effect that overloading of the circuits
might have on overcurrent protection and supply wiring. Appropriate consideration
of equipment nameplate ratings must be used when addressing this concern.
Reliable Earthing - Reliable earthing of rack-mounted equipment must be
l
maintained. Particular attention must be given to supply connections other than
direct connections to the branch circuit. For example, use of power strips.
Note: The maximum install height for the wall mounting installation is 2m.

Connections

Proceed with the following connections:
1. Connect your network cable to ETH1/ETH2.
2. For the Compact, connect your camera network cable to PoE ports 3-6. For the
Advanced, connect your camera network cable to PoE ports 3-6 for cameras and
PoE ports 7-10 for cameras and controllers.
3. Connect a keyboard and a mouse to a USB port, on the back of the device, for local
access.
Note: You can use INTEVO without a monitor or mouse with remote access.
© 2018 Tyco Security Products. All rights reserved.
9