Oki PS-900 Guia Del Usuario página 3

6. REPLACING COIL ASSEMBLIES
1. Push the Power Switch "Off." Wait for the heater tip to reach room temperature.
2. Remove the heater tip from the handle assembly. DO NOT USE METAL TOOLS (SUCH
AS PLIERS) TO REMOVE HEATER TIPS.
3. To disconnect the Coil Assembly from the Soldering Handle depress the button on the Coil
Assembly and pull it away from the Soldering Handle assembly.
4. Insert the new Coil assembly into the handle assembly, you will feel a 'click' as it seats.
7. TROUBLESHOOTING
a. Power LED Not ON
•
Check the power cord
•
Check to see that you have mains voltage
•
Check to see if the power switch is in the ON position
b. Tip Does Not Heat
•
Is the LED Illuminated?
•
Is the Hand-Piece Connected to the Power Supply?
•
Is the PS-CA3 Coil assembly firmly inserted into the PS-H900 Soldering
Handle assembly?
• Is the Tip Firmly Inserted onto the PS-CA3 Coil Assembly?
•
Has a replacement PS-CA3 been tried?
If you cannot resolve the problem after conformation of the above, please contact your local OK
International representative.
www.okinternational.com
4
7000-2250 Rev1
8. SPECIFICATIONS
Power Supply
Ambient Operating Temperature
Maximum Enclosure Temperature
Input Line Voltage
Input Line Frequency
Power Consumption
Output Power
Output Frequency
Power Cord (3-wire)
Dimensions (approx.)
Soldering Handle and Coil Assembly
Tip-to-Ground Potential
Tip-to-Ground Resistance
Idle Temperature Stability
Handle Cord Assembly Length
Connector
Dimensions (approx.)
Overall length (with tip)
Grip diameter
Tip to grip
Tip shaft diameter
Tip length
Workstand
Dimensions
www.okinternational.com
10 - 40°C
65°C
100 - 240 VAC
50/60 Hz
90 Watts max.
60 Watts max. at 22°C ambient temperature
470 KHz
1.83 cm 18/3 SJT
W = 80 mm (3.1"), D = 160 mm (6.3"),
H = 115 mm (4.5")
< 2 mV True RMS, 50-500 Hz
< 2 ohms DC, unit on
± 1.1°C in still air
122 cm – burn proof, ESD safe
3-pin power connector
214 mm (8.43") with standard tips
13 mm (0.51")
58 mm (2.28")
5.5 mm (0.22")
52 mm (2.05") (typical)
W = 105 mm (4.1"), D = 175 mm (6.9"),
H = 90 mm (3.5")
5
7000-2250 Rev1