Replace The Belt - Dirt Devil FD50105RM Manual De Instrucciones

REPLACE THE BELT

1. Take off cover (Refer to
page 16). Remove and
toss the old belt out.
3. With belt in place, pull and
slide brushroll into the
nozzle, making sure that
the brushroll ends are in
the correct orientation (A).
Any other servicing should be done by an authorized service representative. If appliance is
not working as it should, has been dropped, damaged, left outdoors, or dropped into water,
take it to a service center prior to continuing use.
2. Place the new belt on
4. Replace belt cover and
A
the motorshaft, then slip
it in the area without
brushroll bristles.
secure with the three
screws.
17