Taurus TLV 5555 Manual De Instrucciones página 35

English
2- Installation
2.1 - Removing transit bolts
A
B
C
D
2.2 -Plumbing connection
The user will require a tap with a 3/4" gas screwthread outlet and a drain situated
between 50 and 80 cms. above floor level. The watermain pressure must be between 0,4
and 10 bar inclusively.
Proceed as follows:
-Let the water run for a while before connecting the hose.
-Connect the water inlet hose applying the rubber joint provided in the f ittings equipment
bag.
-Position the drainage hose inside a hose of a larger diameter, or rest it well fastened
against any kind of drain at the height indicated.
-Neither of the hoses should be twisted or kinked.
- Use new tubes for connecting to the water supply.
After removing the external packing the drum
must be un-blocked before the machine is
used.
This is done in the following manner:
1.) Unscrew and remove the four screws A-B-
C-D.
2.) Push with a screwdriver at an angle in the
screw holes until the four spacers (H) fall.
These must be recovered and kept.
3.) It is very important to recover these four
spacers (H) because they could cause damage
if they remain inside the machine and also
H
because they will be required to move the
m a c h i n e i n t h e c a s e o f m ov i n g h o u s e .
THERMO
H
H
C
35
C- Cold water connection.
C
H- Hot water connection.
The "H" connection can only be
applied in those machines f itted
for this (Bithermical).