Pull Out The Mains Plug - Tintometer Lovibond EX Serie Manual De Instrucciones

Defrosting
The refrigerator compartment defrosts automatically.
1 The defrost water
drains into a tray situ-
ated below the evapo-
rator. This tray must be
emptied from time to
time.
Pull the tray out to-
wards you and empty.
To avoid having to
2
empty the defrost water collection tray frequently, you can
place a container under the drain opening in the tray.
When operating at a very cold thermostat setting, the interior rear
wall may ice up.
In this case, the appliance must be defrosted manually.

Pull out the mains plug!

•
• Transfer items to other appliances.
• Leave the door of the appliance open while defrosting. After
defrosting mop up the remaining water and clean the appliance.
Do not use any mechanical devices or other
artificial aids for defrosting other than those
recommended by the manufactur er.
Cleaning
Clean the appliance at least twice per year.
Before cleaning always switch off the appliance. Pull out the
mains plug or switch off or unscrew the fuse.
• Clean the inside, equipment and outer walls with lukewarm wa-
ter and a little detergent. Do not use abrasive or acid cleaners or
chemical solvents.
• Ensure that no cleaning water penetrates into the elec trical com-
ponents or ventilation grille.
• The dust should be removed from the refrigeration unit and heat
exchanger - metal grid at the back of the appliance - once a year.
• Do not damage or remove the type plate on the inside of the
appliance. It is very important for servicing purposes.
WARNING
Only clean plastic parts with a damp cloth!
Risk of electrostatic discharge.
Do not use steam cleaners because of the risk
of injury and damage.
EX 160 / EX 220 / EX 300 / EX 490_1 03/2014
Malfunctions
If a malfunction occurs during operation, check whether it is due
to an operating error.
You may be able to rectify the following faults yourself:
• Appliance does not function:
– Is the appliance switched on?
– Is the plug correctly fitted in the mains socket?
– Is the fuse intact?
• Loud running noise:
– Is the appliance set up firmly on the floor?
– Does the appliance cause nearby items of furniture or objects to
vibrate? Please note that noises caused by the refrigerant circuit
cannot be avoided.
• The temperature is not low enough:
– Is the temperature setting correct (see "Setting the temperature")?
– Does the separately installed thermometer show the correct read-
ing?
– Is the ventilation system working properly?
– Is the appliance set up too close to a heat source?
If none of the above causes
apply and you cannot rectify
the fault yourself, contact the
nearest customer service de-
partment stating the type des-
ignation , service number
1 2
and appliance number as
3
indicated on the type plate.
The position of the type plate
is shown in the section entitled Description of the appliance.
Shutting your appliance down
If your appliance is to be shut down for any length of time, switch
it off and disconnect the plug or switch off or unscrew the fuse.
Clean the appliance and leave the door open in order to prevent
unpleasant smells.
The appliance complies with the relevant safety regulations and
EC Directives 2004/108/EC, 2006/95/EC and ATEX 94/9/EC
(EN/IEC 60079-15, IEC 60079-0, EN 1127-1).
GB
13