Tintometer Lovibond EX Serie Manual De Instrucciones página 17

26
26. Insert the pin into the left-hand door mounting.
Use your index finger to hold the pin while you are
assembling the door.
27. Locate the door on the upper pin as
shown in the illustration and guide it
to the lower hinge bracket.
Important
As a result of its heavy weight, the
door must be held secure by one
person.
28. Lift the door upwards and turn the pin
until it fits into the bore hole of the
hinge bracket.
Slowly lower the door downwards.
The lower part of the pin must be fully
engaged in the bore hole of the hinge
bracket.
29. Screw the screw into the
pin again and tighten.
EX 160 / EX 220 / EX 300 / EX 490_1 03/2014
Adjusting the lateral tilt of the door
If the door is at an angle, adjust the angle.
30. Remove middle screw from hinge bracket.
27
31. Undo screws and slide hinge bracket to
the right or left.
Tighten screws.
28
29
30
This screw is no longer needed.
GB
31
17