Rear Panel - Laney LV100 Manual De Instrucciones

REAR PANEL

1
2
Power inlet socket. Make sure the specified voltage is correct for your country!
1
This drawer contains the main safety fuse for the unit.
2
The mains fuse ratings are detailed on page 7 of this manual
Displays the model number, power requirements and serial number of the unit.
3
Connect your headphones here for silent practice. The internal and any extension loudspeakers are
4
automatically muted.
Connect an extension loudspeaker cabinet here, the internal loudspeaker remains connected. The
5
impedance of the extension cabinet must not be less than 8 Ohms. Connecting cabinets that have a lower
impedance than 8 Ohms will result in the amplifier overheating. Continual use in this manner may cause
permanent damage.
Line level FX Loop Return to connect back from an external effects controller.
6
Line level FX Loop Send to connect to an external effects controller.
7
Connect a dedicated Laney FS2 footswitch here to allow remote switching of the reverb and channels.
8
Drive channel must be enabled (with )
12
L Z B 1 2 3 4
3
7
4 5
8
6 7