Elma CRUSHER Serie Manual De Instrucciones página 10

03. INSTRUCTIONS FOR USING.
CRUSHER SERIES 220W MODEL
1. Install the crusher arm (7) to the docking (6)
of the body of the blender (5), both parts must
match.
2. Screw the arm (7) anticlockwise, until it is at-
tached.
3. Connect the blender to a 220-240V/ 50-
60Hz power outlet.
4. Press the ON/OFF button (3) and the blender
will start to operate.
5. Turn the dial (1) and adjust the desired speed
between 4,000 and 20,000 rpm.
6. To keep the blender operating continuously,
the ON/OFF button (3) must be pressed at all
times.
7. To turn off the blender, you must take your
finger off the ON/OFF button (3) and the motor
will stop running.
8. Remove the power cable after each use, clean
the device following the maintenance and clean-
ing instructions, and store the device.
10
CRUSHER SERIES 350W MODEL
1. Install the crusher arm (7) to the docking (6)
of the body of the blender (5), both parts must
match.
2. Attach the arm (7) screwing the mooring nut
(6) anticlockwise, until it is attached.
3. Connect the blender to a 220-240V/ 50-
60Hz power outlet.
4. To start the blender, follow the following steps:
– Press the safety button (2).
– While pressing the security button, press
the ON/OFF button (3) and the motor will
start to run.
– To keep the blender operating continuous-
ly, press the lock button (4). The motor will
remain on continuously, and both hands
can be used to work.
5. Turn the dial (1) and adjust the desired speed
between 4,000 and 16,000 rpm.
6. To turn off the blender, you must take your
finger off the ON/OFF button (3) and the motor
will stop running.
7. Remove the power cable after each use, clean
the device following the maintenance and clean-
ing instructions, and store the device.