baltur BGN 60 Lx Guía Rápida página 22

Start-up ACS 160 / 400
The safety instructions must be followed at all times during the start-up procedure, see Safety.
Note! Check that starting the motor does not cause any danger.
1. Apply mains power
The first time the drive is powered up, it is controlled from the
Control Terminals (remote control, REM).
To switch to control panel use (local control, LOC), press and hold
the MENU and ENTER buttons down simultaneously until first Loc
is displayed.
2. Check Parameters
The following parameters must be set
using the information from the motor name
plate (see example on right).
9905 MOTOR NOM VOLT
9906 MOTOR NOM CURR
9907 MOTOR NOM FREQ
9908 MOTOR NOM SPEED
9909 MOTOR NOM POWER
9910 MOTOR COS PHI
20
FREQUENCY CONVERTER
REM
0.0
OUTPUT
MENU
LOC REM
ENTER
LOC
0.0
OUTPUT
Hz
FWD
Hz
FWD